Inspection requirements and overload conditions of industrial dust collectors for dust removal and environmental protection equipment
The industrial dust collector must be inspected before use. Effectively open the cylinder cover to effectively check whether the dust storage bag is tight and the suction mouth is fastened. Then effectively cover its cylinder cover. The industrial dust collector needs to be effective. Check its power supply and voltage. If necessary, you can pay attention to the motor's forward and reverse rotation.
Part of the industrial dust collector uses its belt-driven industrial vacuum cleaner to effectively replace its new conveyor belt. During use, the rear door of the vacuum cleaner can be opened and then replaced. If the belt is loose, open the side door and adjust Just control the nut to the proper position.
Industrial dust collectors need to pay attention to their ordinary machines are strictly prohibited to use in flammable and explosive places, unless it is some more special materials, filter bags can not absorb ignition flames and ultra-high temperature waste, the equipment is not filtered It is strictly forbidden to use the filter and dust filter bag.
The industrial dust collector will continue to be used without its dust filter bag, which will directly damage its fan. When the equipment's main filter and filter bag are damaged, it needs to be replaced in time during use. continue to use.
The dust collection hose of an industrial dust collector cannot be crushed and worn. The temperature of the rear casing of the equipment is relatively high, especially after continuous working for a long time, you need to pay attention to burns, and the dust storage bucket has accumulated too much miscellaneous The materials should be cleaned in time, and the filter bags and filters should be cleaned regularly to ensure smooth flow.
After the industrial dust collector is overloaded, the thermal relay in the control box will automatically cut off its power supply during use. In this case, you must unplug the power supply, and then effectively investigate the cause. After the thermal relay is reset, Use in line; after work, cut off the power and store in a cool and dry place.
Before using the industrial dust collector, it is necessary to effectively open the cylinder cover to effectively check whether the dust storage bag is tight and the suction port is old, and then effectively cover the cylinder cover and check its power supply voltage. If necessary, Effectively pay attention to the forward and reverse of its motor.
Part of the industrial dust collector will use its belt-driven industrial vacuum cleaner. When it is used, it needs to be replaced with a new conveyor belt. When it is used, its rear door of the vacuum cleaner is opened and then replaced. If the belt is loose, it is necessary to open it. Side door, and then effectively adjust and control its nut to the appropriate position.
When using industrial dust collectors, please note that the machine is strictly forbidden to use in flammable and explosive places. If the filter bags of special materials are not capable of absorbing ignition flames and ultra-high temperature waste, the equipment will not have its filter and dust bag. It is strictly forbidden to use it under the circumstances, otherwise the fan will be damaged directly.
When the filter in the industrial dust collector or the filter bag is damaged, it must be replaced in time during use. Do not continue to use it. The suction hose must not be crushed, stepped on, or in the rear box. The temperature of the body shell is high, especially after continuous working for a long time, pay attention to burns.
The industrial dust collector's biological dust storage bucket accumulates excessive debris, which needs to be cleaned in time during use, and then regularly clean its filter bag and filter, which can effectively ensure its smoothness. After the vacuum cleaner is overloaded, the heat in the control box is controlled. The relay will automatically cut off the power. At this time, you must unplug the power plug to find out the reason. After the thermal relay is reset, it will be used in the line.