The core of this solution is to add a double dust cleaning device to the uniformly distributed boards of the dust removal and environmental protection equipment , that is, a vibration dust cleaning device and a brush cleaning device. The rapping dust cleaning device further includes a rapping driver and a rapping actuator. The brush-type cleaning device includes a cleaning driver and a cleaning actuator. An ash falling gap is provided between the lower end of the uniformly distributed plate and the inner wall of the casing. Under the action of the double ash cleaning device, the uniform distribution board enters the ash hopper through the ash falling gap, and is discharged by the rotary valve or ash residue drag chain.
The rapping driver of this solution is composed of a rapping motor and a rapping shaft. The rapping motor is installed on the outer wall of the electric dedusting housing. The rapping shaft is installed in the housing through a bearing. One end of the rapping shaft passes through the electric dedusting housing. The side wall is connected to the output end of the rapping motor through a coupling; the rapping actuator consists of a rapping hammer and an anvil that is mounted on the rapping shaft; the anvil is installed on a uniform board and The corresponding position of the hammer. The rapping motor here is a servo motor or an asynchronous motor, and the rapping motor is connected to the controller signal.
The brush-type cleaning driver of this solution is composed of a cleaning motor, a first cleaning shaft, and a second cleaning shaft. The cleaning motor is installed on the outer wall of the housing of the dust removal and environmental protection equipment through a bracket. The first cleaning shaft and the second cleaning shaft are mounted on the bearing through a bearing. In the housing, the second cleaning shaft is arranged directly below the first cleaning shaft in parallel; one end of the first cleaning shaft passes through the side wall of the electrostatic precipitator housing and is connected to the output end of the cleaning motor through a coupling; the first cleaning shaft and the Two identical sprocket wheels are installed on the second cleaning shaft; sprocket wheels in the same position on the first cleaning shaft and the second cleaning shaft are connected in a closed-loop transmission by a chain; the cleaning actuator here includes a high-temperature-resistant exhaust brush , The upper limit plate and the lower limit plate; the row brush is fixed on the chain; the row brush is in contact with the uniformly distributed plate; sensors are installed on the upper limit plate and the lower limit plate. The cleaning motor is a servo motor or an asynchronous motor, and the cleaning motor is connected to the controller signal.